Saturday, June 4, 2011

XADO Gel-revitalizant for Cylinders (aerosol can, 10 ml)

XADO Gel-revitalizant for Cylinders (aerosol can, 10 ml) Reviews


Other Picture


XADO Gel-revitalizant for Cylinders (aerosol can, 10 ml) Feature

  • increases compression in cylinders
  • restores geometry of cylinders
  • removes scuffs and scratches up to 0,1 mm
  • protects cylinders from wear at cold start
  • reduces noise and vibration
Designed for restoring repair and wear protection of the engine cylinder-piston group without disassembling. After XADO revitalization the cylinder geometry restores, the inner diameter reduces, ellipse deformation of cylinders disappears preventing expensive overhaul. Application: Step 1: Warm up the engine up to the operating temperature. Step 2: Remove the spark-plug and disconnect the central wire of ignition distributor and commutator. Step 3: For two-stroke engines fix the piston in the upper dead point (in order to avoid getting the gel into the inlet and outlet windows). Step 4: Empty the content into the cylinder. Note! Apply the content onto the cylinder wall and not on the piston!!! Step 5: Perform 15-20 piston strokes (by crank, towing, turning of a driving wheel etc.). Step 6: Screw in the spark-plug and start the starter 3-4 times for 3-4 sec in 15-20 sec intervals. Step 7: For two-stroke engines the content of one more tube should be dissolved in 5 - 10 ml of motor oil and added into the fuel tank. Step 8: Connect the central transmission, commutator; start the engine and operate at idling for 15 min. Step 9: Operate in a normal mode. Dosage: 1 cylinder - 1 tube. Note! *Use medical syringe with a plastic tube in hard-to-reach places. In this case the gel should be dissolved in 5 - 10 ml of motor oil. In order to avoid hydroblow the total volume of the fluid added into cylinder must not exceed 20 ml! *At diagnostics always check the adjustment and accuracy of the valve mechanism! General characteristics of the cermet layer: microhardness - 750 kg/mm2; high corrosion resistance; roughness Ra up to 0,06 mkm.


Visit Store Now !!

Detail Products

Detail Reviews




Jun 04, 2011 20:02:04

No comments:

Post a Comment